Sunday 22 July 2007

Steady as she goes

I can confirm my homemade "three point steady" does work, I made this with it :-



It's the RepRap extruder drive screw which fits in the bearings shown in my last post. The RepRap instructions say to use a blow torch and plumber's flux to attach the steel cable but I found it easier to use a soldering iron and electrical solder.

Here it is installed with a small G-clamp in place of the top half of the pump :-



And here is a video of it being tested with a variable DC power supply until it shed the clamp :-

No comments:

Post a Comment